7 Most Common Causes of Low Water Pressure in Maryland

What can be worse than turning your shower knob on, only to find the water’s not even enough to wash the soap off of you. That’s a bummer, right?

Well, in Maryland low water pressure seems like a problem that many of us face quite often. People have been innovative enough to figure out solutions by themselves, but to no avail. As some solutions have some loopholes, while others aren’t quite effective as others.

So, what exactly leads to a low water pressure scenario in Maryland? Is it your water pressure in tanks? Are water booster pumps a feasible solution? Let us find out.

Causes for Low Water Pressure in Maryland

1. Poor Installation

Poor quality of installation of your faucets and fixtures in the bathroom can be a reason for low water pressure in Maryland. This might be a common cause for many to experience a low water pressure in their showers and other equipment.  

A poor installation of the water fixtures front can lead to the flow of water being hampered due to any leaks, valves or any other generic feature of the entire plumbing system.

2. Plumbing Leaks

A leak can hamper your home’s regular water flow. This can also influence the existing water pressure at your home and not allow water to flow completely. Moreover, the leak can be at a specific location or in the primary system itself.

3. Normal Wear and Tear

It is only evident that your plumbing might face normal wear and tear once a year or so. If your plumbing system is old, problems might arise more often than when it’s newer. This wear and tear can also impact your water pressure, due to a leak, corrosion or any other factors.

4. Municipal Water Supply

It isn’t necessary that it’s always the supply systems at your place that are at fault. Municipal supply, right from the source can also affect the water pressure at your place. Hence, it is advisable in such cases to check up with the concerned department in your city council.

5. Clogged Water Filters

Water filters tend to get clogged due to debris and other impurities they tend to accumulate over a period of time. These filters can further hamper the regular water flow by creating a dam-like situation within your plumbing systems.

6. Clogs & Dirt in the Faucet

Our regular faucets in homes can also have an issue, leading to hampering the flow of water. In order to figure out whether it’s the plumbing system or just the faucet at fault, this is what you can do. 

Remove the faucet at the end, and turn on the water. If the water is back to its flow, there’s some issue with the faucet. However, in case the water pressure remains the same, you should probably check your plumbing systems and ask your neighbors too.

7. Master Shut Off Valve is Shut

The main shutoff valve at your home is the place where your water flow and pressure can be determined. If you’re facing consistently low water pressure, it’s always recommended to go back into your basement or garage and check on the same.  

In case it’s a gate valve, it is required to turn around in a completely anti-clockwise direction. Moreover, if it’s a ball valve, make sure the lever handle is parallel.

What Steps Can You Take For Low Water Pressure in Maryland?

In case, there isn’t a scenario in which the city’s water supply is disrupted and there’s a hindrance in the water pressure from your home itself, here are a few steps that you can take.

1. Check for clogs in the faucet and other filtration and plumbing system at your place

2. Inspect all systems and plumbing at your home. If everything’s intact, it might be an issue in the water supply of your area. You can go for a water pressure tank, well pressure tank or a water booster pump too

3. Get your plumbing inspected for repair, leaks etc regularly

4. New water pump or booster.

Key Takeaways: Causes are common, but what’s a feasible solution?

Many cities in Maryland, tend to face a similar situation around water scarcity at times. Although, there have been quite some interventions by the government on the issue to no avail.

While booster pumps are suggested by many, some also suggest water pressure and well pressure tanks sort their water woes out. Whatever might be the reason for low water pressure, one thing is definite- you might need a professional for the same.

Save yourself the irritation and time of fighting the low water pressure alone.

Getting an expert on board can help you determine what’s exactly wrong, and save you some additional cost and time that you’d have taken in the first place.

Whether you’re going for a booster pump or a well water pressure tank, the choice is yours, but the only feasible way to get it done seems through a professional.